How to attach the FlashCap-Nylon-Convex

Installing the FlashCap-Nylon-Convex-24

Deburring

To ensure the best pressing feel, our caps are made of pure nylon material.

As a result, burrs are likely to remain on the outer side surfaces of the cap, which may cause increased friction with the sidewalls of the switch body when installed on FlashTap (Silent/Standard versions). There is no issue when used with Specter.

Therefore, before installation, please remove any burrs from the sides by trimming them with a utility knife or sanding them down with sandpaper. It is sufficient to smooth the surface until it feels smooth to the touch.

In the image below, the left side shows the burrs on the cap surface circled in red. The right side shows the cap after the burrs have been removed.

Installation

To install, rotate the cap while aligning the wider opening of the cap with the tabs on the button body.

Installing the FlashCap-Nylon-Convex-30

As long as the cross shape is correctly aligned, you can install it simply by pushing it firmly all the way in.